B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 171)

Airborne Enterprise CLI Reference Manual 171
pass / pass-p1
Command pass | pass-p1
Arguments [none]
Security
Level
2 (data)
Device Type Serial, UART
Default [blank]
Description Creates a data bridge between the wireless and Serial 1 (UART1) interface. The behavior of the
command depends upon the interface it is issued from and the mode the Serial 1 (UART1) interface is
in.
Issuing Interface UART1 State Wireless State Results
Wireless Interface
CLI CLI No data bridge formed.
Listen CLI Data bridge formed.
Pass CLI No data bridge formed.
UART1 CLI N/A Data bridge formed 1 .

1. Network server must be available and that network server parameters have been
configured correctly and that transport has been correctly defined. Please refer to
section 6.3.3 for the configuration requirements.
Use of the –p1 suffix is optional.