B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 132)

132 Airborne Enterprise CLI Reference Manual
eth-dhcp
Command eth-dhcp
Arguments enable | disable
Security
Level
3 (config)
Device Type Ethernet
Default disable
Description Configures the DHCP client on the Ethernet interface to be enabled or disabled. If the DHCP client is
enabled the Ethernet interface will use DHCP to obtain an IP configuration.
If DHCP fails the Ethernet interface configuration will be determined by the setting for the eth-dhcp-fb
command.
enable Enables DHCP (Client) on the Ethernet interface.
disable Disable DHCP (Client) on the Ethernet interface.
 If eth-dhcp is enabled, wl-dhcp must be disabled and vice versa. The Ethernet
DHCP client and the Wireless DHCP Client cannot both be enabled at the same time.
The default setting is disable.
eth-dhcp-acqlimit
Command eth-dhcp-acqlimit
Arguments [Integer]
Security
Level
3 (config)
Device Type All
Default 150
Description Configures the number of seconds that the Module should wait to acquire its IP configuration using DHCP
before applying the DHCP fallback algorithm for the Ethernet interface.
Requires eth-dhcp-fb to be enabled for IP fallback to be utilized.
This is an integer with a range of 1-255 seconds.

Setting eth-dhcp-acqlimit 0 will turn IP Fallback off for the Ethernet interface.
The default setting is 150.