Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 81)

Viewing Controller Policies
www.lsi.com/channel/products 69
selected method. This policy does not apply to drives that are attached to
an expander. This policy can only be set and only shows in 3BM.
• Auto-Verify Preferred Date and Time. Sets the default date and time for
auto-verify to run, when the Verify Schedule follows the weekly "Basic"
schedule and Auto-Verify is enabled for specific units. Note that in
3DM2, the Basic and Advanced Auto-Verify schedule is set on the
Schedule page. Enabling or Disabling Auto-Verify is a Unit Policy and is
set on the Create Disk Array screen in 3BM and the Controller Settings
page in 3DM2.
Some additional policies can be set at the unit level. For more information,
see “Setting Unit Policies” on page 100.
Viewing Controller Policies
You can view the current state of controller policies in 3DM2, in the Other
Controller Settings section at the bottom of the Controller Settings page (See
Figure 32). Only the Auto-Rebuild, Auto-Carving, and Carve Size policies
can be changed on this page. The other policies can be changed in 3BM or
through the CLI. For a summary of the initial default settings, see Table 5,
“Default Settings for Policies/Background Tasks,” on page 32.
To view controller policies in 3DM2
• Choose Management >> Controller Settings from the menu bar.
The policies that appear under Other Controller Settings vary, depending
on the controller model you are using.