Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 247)

Error and Notification Messages
www.lsi.com/channel/products 235
If the drive shows up, then you will know which hardware component
was defective.
If the drive still does not show up, contact 3ware Technical Support.
Error and Notification Messages
Error and notification messages are issued by the 3ware RAID controller
when an error is detected or when an action is completed. These messages are
sometimes referred to as AENs (asynchronous event notifications).
AEN messages are displayed on the 3DM2 Alarms page and CLI Show
Alarms page.
On the 3DM2 Alarms page, you can click on the message to jump to help text
about that message. You can also look the message up in the list below. In
3DM2, the message number is the last few digits within the parentheses at the
beginning of the message description. For example, in the string
(0x04:0x002B) , “ 002B ” is the message number. To find additional
information about the message 2B, you would look up 002B in the list below.
Note that the messages are listed below in hex order, since the message
numbers are in hex.
Error and notification messages are listed in Table 14. Descriptions of each
are provided after the table.
Table 14: Error and Notification Message List
Value Message
0001 Controller reset occurred
0002 Degraded unit
0003 Controller error occurred
0004 Rebuild failed
0005 Rebuild completed
0006 Incomplete unit detected
0007 Initialize completed
0008 Unclean shutdown detected
0009 Drive timeout detected