Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 270)

Chapter 12. Troubleshooting
258 3ware SATA+SAS RAID Controller Card Software User Guide, Version 10.2
Action
None required.
This is considered a normal part of operation. Not all types of RAID units
need to be initialized in order to have full performance. The initialize will not
erase user data, but will calculate and write parity data or mirror data to the
drives in the unit.
See Also
“About Initialization” on page 146
0030 Drive not supported
Event Type
Error
Cause
3ware 8000 and 9500S Serial ATA controllers only support UltraDMA-100/
133 drives when using the parallel-to-serial ATA converter. This message
indicates that an unsupported drive was detected during rollcall or a hot swap.
This message could also indicate that the parallel-to-serial converter was
jumpered incorrectly.
Action
Use a parallel ATA drive which supports UDMA 100 or 133 and check that
the parallel-to-serial converter was correctly jumpered to correspond to
UDMA 100 or 133 drives.
See Also
For a list of compatible drives, see the Interoperability list on
http://www.lsi.com/channel/support/marketing_resources , -Select Data &
Interoperability tab.