Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 72)

Chapter 5. 3DM2 (3ware Disk Manager 2) Introduction
60 3ware SATA+SAS RAID Controller Card Software User Guide, Version 10.2
2 In the E-mail Notification section of the 3DM2 Settings page, enter or
change the settings you want.
• Enable or Disable all notifications.
• Set the severity level of events for which e-mail notifications are sent.
• Specify the email address of the sender. This address appears in the
“From” field of the e-mail.
• Enter the e-mail address(es) to which notifications are sent. (Separate
multiple addresses with a comma (,) a semicolon (;), or a space ( ).
• Enter the SMTP server name or IP of the mail server for the computer
where the 3ware controller is installed.
• If your email server requires authentication, enter the Mail Server
Login and Password.
• If your email server requires or supports encrypted email, select Yes
in the field Mail Server Port Uses SSL .
Tip: If you are not sure whether any part of the set up applies to you,
try enabling it, and then use the Send Test Message feature to try out
the configuration setting. If the configuration is not correct, an error
message appears at the top of the page. If you do receive an error,
disable the setting, and try the test again.
You also might want to refer to KnowledgeBase article # 15538, at
http://kb.lsi.com . This article explains how to use an gmail account as
an alternate method to get your email notification working.
3 Click Save E-mail Settings .
To send a test message
You can send a test message to make sure that you have entered the e-mail
notification settings correctly.
• Click Send Test Message .