Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 120)

Chapter 7. Configuring Units
108 3ware SATA+SAS RAID Controller Card Software User Guide, Version 10.2
To enable or disable the Auto-Verify policy for an existing unit
through 3DM2
1 Choose Management >> Controller Settings from the menu bar.
2 In the Unit Policies section of the Controller Settings page check the
Auto-Verify box for the appropriate unit. (To disable this policy, uncheck
the box.)
The page refreshes, and a message at the top confirms the change you
have made.
To enable or disable the Auto-Verify policy for an existing unit
through 3BM
1 At the main 3BM screen, select the unit by highlighting it and pressing
Enter .
An asterisk appears in the left-most column to indicate that it is selected.
2 Tab to the Maintain Unit button and press Enter .
3 On the pop-up menu, select Configure and press Enter .
4 In the Configure Disk Array screen, Tab to the field Auto-Verify .
5 After completing any other changes you wish to make, tab to OK and
press Enter .
Setting Overwrite ECC (Continue on Source Error
When Rebuilding)
The Overwrite ECC (Continue on Source Error When Rebuilding) policy
is available for units which are redundant. (For units which are not redundant,
this option is not shown on the screen.) When this policy is set, ECC (Error
Correcting Code) errors are ignored when they are encountered during a
rebuild. (ECC errors are typically defects that have been detected in the drive
since initialization.) When this policy is not set, if a unit is rebuilding, the
rebuild will abort when it encounters an ECC error and the unit will be set
back to Degraded.
Since enabling this policy could result in the loss of some source data in the
event of source errors, the default is to not enable this policy. Select this
option only if you want to ensure that a rebuild will complete successfully
without manual intervention. If the rebuild fails and
Overwrite ECC
(Continue on Source Error When Rebuilding) is not selected, then you
have the option to start another rebuild manually. After completing a rebuild
with this policy enabled, it is recommended that you execute a file system
check when the rebuild completes.