HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 99)

HEIDENHAIN CNC PILOT 4290 99
3.6 Mac
h
ine Displa
y
Spindle display
„ Symbol appears in white: Disabled
„ Numeral in spindle symbol: Gear range
„ “H”/Numeral: Selected spindle
„ Spindle status
„ Bar graphic: Feed rate override in %
„ Upper field: Spindle speed override
„ Lower field:
„ Current speed
„ With stationary spindle: Nominal speed (gray text)
„ With position control(M19): Spindle position
Spindle status:
Direction of spindle
rotation M3
Direction of spindle
rotation M4
Spindle stop
Spindle in position
control (M19)
C axis is “activated”
Overview of enabled elements
Shows the enabling status of up to 6 NC channels, 4 spindles, and 2 C-axes. Enabled
elements are marked (green).
„ Display group at left: Enabled
„ F: Feed rate
„ D: Data
„ S: Spindle
„ C: C axis
„ 1..6: Number of the slide/spindle of the C axis
„ Display group in center: Status
„ Zy – left dash: Cycle on/off
„ Zy – right dash: Feed Stop
„ R=Reference run
„ A: Automatic mode
„ H: Manual control
„ F: Retracting (after crossing the limit switches)
„ I: Inspection mode
„ E: Set-up switch
„ Display group at right: Spindle
„ Display for direction of rotation left/right
„ Both active: Spindle positioning (M19)
Display elements