HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 81)

HEIDENHAIN CNC PILOT 4290 81
3.5 A
u
to
matic Mode
3.5 Automatic Mode
Overview of soft keys in Automatic mode
Switch to “graphic display”
Switch the machine display
Define block display for more
channels
Display basic blocks (individual paths
of traverse)
Suppress/permit variable output
Set single-block mode
Program stop at M01 (selectable
stop)
Run a start-block search
In Automatic mode, the data are entered and displayed
according to control parameter 1 either in meters or in
inches. The setting in the “program head” of the NC
program governs the execution of the NC part program. It
has no influence on operation or display.