HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 571)

HEIDENHAIN CNC PILOT 4290 571
7.
3 Mac
h
ine P
a
ra
met
e
rs (MP)
7.3 Machine Parameters (MP)
Value ranges of machine parameters:
„ 1..200: General machine configuration
„ 201..500: Slides 1 to 6 (50 positions per slide)
„ 501..800: Tool carriers 1 to 6 (50 positions per tool carrier)
„ 801..1000: Spindles 1 to 4 (50 positions per spindle)
„ 1001..1100: C-axes 1 to 2 (50 positions per C axis)
„ 1101..2000: Axes 1 to 16 (50 positions per axis)
„ 2001..2100: Various components of the machine (these parameters
are not used at present)
General machine parameters
General machine parameters
6 Tool measurement
These parameters define how to determine the tool lengths in set-up mode.
„ Type of tool measurement:
„ 0: Touch-off
„ 1: Touch probe
„ 2: Optical gauge
„ Measuring feed: Feed rate for approaching the touch probe
„ Clearance distance: Minimum distance, which has to be traversed in the opposite direction to the measuring
direction, to retract the touch probe after the stylus has deflected.
7 Machine dimensions
Within the framework of variable programming, machine dimensions can be used in NC programs. The use of the
machine dimensions is defined only by the NC program.
„ Dimension n X, Y, Z, U, V, W, A, B, C (n: 1 to 9)
17 Display settings
The “Display mode” defines the position display (actual value display) within the machine display.
„ Actual position display type
„ 0: Actual value
„ 1: Following error
„ 2: Distance of traverse
„ 3: Tool point — with reference to machine datum
„ 4: Slide position
„ 5: Distance from reference dog to zero pulse
„ 6: Nominal position
„ 7: Difference from tool point to slide position
„ 8: Nominal director position