HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 615)

HEIDENHAIN CNC PILOT 4290 615
8.1 T
o
ol D
a
tabase
Additional information:
„ Dialog box 3: see “Multipoint tools, tool life monitoring” on
page 620
„ see “Explanation of tool data” on page 622
„ see “Tool holder, tool mount” on page 624
Parameters in dialog box 2 G S TP
T hold. DIN: Type of tool holder – • –
T hold. heig. (wh): Height of tool holder – • –
T hold. brea. (wb): Width of tool holder – • –
Breadth (dn): Tool width (tool tip to shank back) – • –
Shank d (sd): Shank diameter – • –
Design (A)
„ Threading tool, recessing tool, parting tool,
recess-turning tool: Left-hand or right-hand tool
„ Button tool with tool position 1..4: Left-hand,
right-hand or neutral tool
• • •
Available as of software version 625 952-05.
Position angle (rw): for cranked recessing and
recess-turning tools when used with the B axis.
• • •
Pitch: Thread pitch • – •
Available: Physical availability – – •
Picture no. – • –
Cutting material – – •
CSP comp.: Compensation factor for cutting
speed – – •
FDR comp.: Compensation factor for feed rate – – •
Depth comp.: Compensation factor for cutting
depth – – •
Mount type • – •
„ The “Design” parameter determines whether the tool
reference point is located on the right/left side.
„ For neutral button tools, the tool reference point is
located on the left side.
„ As of software version 625 952-05: With cranked
recessing and recess-turning tools the recessing
process must always be executed perpendicular to one
of the principal axes.