HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 70)

70
3.3 T
a
ble f
o
r T
ools and Chuc
king Equipment
Comparing a tool list with an NC program
The CNC PILOT compares the current tool list with the entries in the
NC program last translated in automatic mode. The entries in the
TURRET section are considered to be nominal tools.
The CNC PILOT shows the following tools marked:
„ Actual tool not equal to nominal tool
„ Actual tool not occupied, nominal tool occupied
Tool locations that are not assigned in the NC program cannot be
selected.
Comparing a tool list
Select Setting up > Tool list > Compare list
The CNC PILOT shows the current contents of the tool list and marks
deviations from the programmed tool list.
Select marked tool pocket
Press the INS key (or ENTER). The CNC PILOT opens
the “nominal-actual comparison” dialog box
Accept the ID number of the “nominal tool” in the
tool list
Look for the tool in the database
Insert the tool.
Danger of collision
„ Tool pockets that are occupied but, according to the NC
program, are not needed, are not marked.
„ The CNC PILOT accounts for a tool entered, even if it
does not correspond to the nominal assignment.