HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 305)

HEIDENHAIN CNC PILOT 4290 305
4.32 Other G F
unctions
Component position G66
The simulation can only depict tool positions and movements if the X
and Z position, or the X, Y and Z position, is known. For slides that
move in only one direction (for example a parting slide), add the
missing coordinates with G66. In “Shift” you can include a zero point
shift. On the basis of these data, the CNC PILOT simulates slides with
one axis.
Waiting for time G204
G204 interrupts an NC program up to a specified moment.
Update nominal values G717
G717 is used to update the nominal position values of the control with
the axis position data.
Application:
„ Deleting the lag error.
„ Standardization of the slave axes after deactivating a master-slave
coupling.
Parameters
X Starting point Component position G66
I Shift
Z Starting point Component position G66
K Shift
Y Starting point Component position G66
J Shift
Parameters
D Tag [1-31] (default: First possible time H, Q)
H Hour [0-23]
Q Minute [0-59]
Use G717 only in “expert programs.”