HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 572)

572
7.
3 Mac
h
ine P
a
ra
met
e
rs (MP)
Machine parameters for slides
18 Control configuration
„ PLC is to perform counting of workpieces:
„ 0: CNC is to perform counting of workpieces
„ 1: PLC is to perform counting of workpieces
„ M0/M1 for all NC channels
„ 0: M0/M1 triggers a STOP on programmed channels.
„ 1: M0/M1 triggers a STOP on all channels.
„ Interpreter stop upon tool change
„ 0: No interpreter stop
„ 1: Interpreter stop. Look-ahead block interpretation is stopped, and reactivated after the T command has been
processed.
General machine parameters
Slide parameters
204, 254, .. Feed rates
Rapid traverse speed and feed rate when slide is moved with the axis-direction keys (jog keys).
„ Rapid traverse contouring speed for manual control
„ Feed rate contouring speed for manual control
205, 255, .. Protection zone monitoring
The protection zone dimensions are defined for individual axes (MP 1116, ...). Define in this parameter whether
the protection zone dimensions are to be monitored.
„ Monitoring
„ 0: Protection zone monitoring OFF
„ 1: Protection zone monitoring ON
The other parameters are not used at present.
208, 258, .. Thread cutting
If the “coupling/uncoupling path” is not programmed in an NC program, parameter values are used.
„ Coupling path: Acceleration path at the beginning of a threading cut in order to synchronize the feed axis
with the spindle.
„ Decoupling path: Deceleration path at the end of a threading cut.
209, 259, .. Slide switch-off
„ Slide
„ 0: Switch off the slide
„ 1: Do not switch off the slide