HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 601)

HEIDENHAIN CNC PILOT 4290 601
7.
6 Mac
h
ining P
a
ra
met
e
rs
Drilling – Safety clearances
Drilling – Machining
The parameters apply to drilling with deep-hole drilling cycle (G74).
Safety Clearances
Internal safety clearance [SIB]
Retraction distance for deep-hole drilling (“B” for G74).
Driven drills [SBC]
Safety clearance for driven tools on end face and lateral
surface.
Stationary drills [SBCF]
Safety clearance on end face and lateral surface for tools that
are not driven.
Driven taps [SGC]
Safety clearance for driven tools on end face and lateral
surface.
Stationary taps [SGCF]
Safety clearance on end face and lateral surface for tools that
are not driven.
Machining
Drilling depth factor [BTFC]
1st drilling depth: bt1 = BTFC * db
(db: drill diameter)
Depth reduction [BTRC]
2nd drilling depth: bt2 = bt1 – BTRC
The subsequent drilling steps are reduced accordingly.
Diameter tolerance for drill [BDT]
For selecting the desired drill (centering drills, countersinks,
stepped drill, taper reamers).
„ Drilling diameter: DBmax = BDT + d (DBmax: maximum
drilling diameter)
„ Tool selection: DBmax > DB > d