HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 294)

294
4.29 Cont
our F
o
llo
w
-Up
4.29 Contour Follow-Up
Automatic contour follow-up is not possible with program branches or
repetitions. In these cases you control the contour follow up with the
following commands.
Saving/loading contour follow-up G702
G702 saves the current contour or loads a saved contour.
Program G702 for one slide.
Contour follow-up G703
G703 is used to deactivate the contour follow-up.
Parameters
Q Save/load contour
„ Q=0: Saves the current contour. The contour follow-up is
not affected.
„ Q=1: Loads the saved contour. The contour follow-up is
continued with the loaded contour.
Parameters
Q Contour follow-up on/off
„ Q=0: Off
„ Q=1: On