HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 612)

612
8.1 T
o
ol D
a
tabase
Overview of tool types
Lathe tools
„ Roughing tool (type 11x)
„ Finishing tool (type 12x)
„ Threading tool, standard (type 14x)
„ Recessing tool (type 15x)
„ Parting tool (type 161)
„ Button tool (type 21x)
„ Copying tool (type 22x) – TURN PLUS uses copying tools only for
undercut types H and K.
„ Recess-turning tool (type 26x)
„ Knurling tool (type 27x)
„ Special turning tool (type 28x)
Main machining direction (third digit of tool type): see figure
Drilling tools
„ Centering tool (type 31x)
„ NC center drill (type 32x)
„ Twist drill (type 33x)
„ Indexable-insert drill (type 34x)
„ Counterbore (type 35x)
„ Countersink (type 36x)
„ Tap (type 37x)
„ Step drill (type 42x)
„ Reamer (type 43x)
„ Tap drill (type 44x)
„ Delta drill (type 47x)
„ Turn-out tool (type 48x) – not used by TURN PLUS
„ Special drilling tool (type 49x)
Main machining direction (third digit of tool type): see figure
Special tools are tools that do not fit into any other type.
They are not used for contour cycles and are not used by
TURN PLUS..