HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 616)

616
8.1 T
o
ol D
a
tabase
Drilling tool parameters
Example: Tool type 311
Parameters in dialog box 1 G S TP
ID: Tool ID number • • •
X, Z, Y dim. (xe, ze, ye): Setting dimensions • – –
Diamet. (db): Drill diameter • • •
Bor.ang. (bw): Drill angle • • •
Tip an. W (sw): Point angle • • •
Shnk.di. (d1): Shank diameter • • •
Shnk.ln. (l1): Shank length • • •
Pos.ang. (rw): Position angle • • –
X, Z, Y comp. (DX, DZ, DY): Compensation values
(maximum +/– 10 mm) • – –
Dir.rot.: Direction of spindle rotation • – •
Usab.lg.(nl): Usable length of drill – – •
Type of tap:
„ 0: Undefined
„ 11: Metric
„ 12: Fine-pitch thread
„ 13: Inch thread
„ 14: Pipe thread
„ 15: UNC
„ 16: UNF
„ 17: PG
„ 18: NPT
„ 19: Trapezoid thread
„ 20: Other
• – •
Strtlen (al): Length of first cut • • •
The “Type of tap” parameter is used for determining the
thread parameters; the AWG accounts for this parameter
when selecting a tool.