HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 584)

584
7.
5 Set-Up P
a
ra
met
e
rs
Tool life monitoring
„ Tool life switch (tool life monitoring/quantity monitoring)
„ 0: Off
„ 1: On
„ Load monitoring
„ 0: Off
„ 1: On
Additive compensation
„ Compensation 901..916 in X
„ Compensation 901..916 in Z
The CNC PILOT manages 16 compensation values (X and Z) that can be activated/deactivated in the NC program (see G149,
G149 Geo).
If an additive compensation value is changed in Automatic mode, this parameter is changed accordingly.
Deletion Level/Cycle
„ Deletion level [0..9]
„ Deletion cycle [0..99]
„ 0: NC blocks with this deletion level are never executed.
„ 1: NC blocks with this deletion level are always executed.
„ 2..99: NC blocks with this deletion level are executed every Nth time.
A skip level can be assigned a skip cycle. As a result, NC blocks containing the specified skip level are executed each nth time.
Activate/deactivate the skip levels in automatic mode.
Set-up parameters