HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 328)

328
4.36 Subpr
ogr
a
ms
Dialog texts in subprogram call
You can define up to 19 parameter descriptions that precede/follow
the input fields in an external subprogram. The CNC PILOT
automatically sets the unit of measure for parameter values to the
metric system or inches.
The parameter descriptions can be positioned within the subprogram
as desired.
Parameter descriptions (see table at right):
[//] – Beginning
[pn=n; s=parameter text (up to 16 characters) ]
[//] – End
pn: Parameter designations (la, lb, ...)
n: Conversion number for units of
measurement
„ 0: Non-dimensional
„ 1: mm or inches
„ 2: mm/rev or in./rev
„ 3: mm/min or in./min
„ 4: m/min or ft/min
„ 5: Rev/min
„ 6: Degrees (°)
„ 7: µm or µinch
Example:
. . .
[//]
[la=1; s=bar diameter]
[lb=1; s=starting point in Z]
[lc=1; s=chamfer/rounding arc (-/+)]
. . .
[//]
. . .