HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 577)

HEIDENHAIN CNC PILOT 4290 577
7.
4 Contr
o
l P
a
ra
met
e
rs
7.4 Control Parameters
General control parameters
General control parameters
1 Settings
„ Suppressing printer output: With the PRINTA command in the NC program you can output data to a printer
(see also control parameter 40).
„ 0: Suppress the output
„ 1: Enable the output
„ Metric / Inches: Setting for the unit of measure.
„ 0: Metric
„ 1: Inches
„ Format of the position displays (actual value displays).
„ 0: Format 4.3 (4 integral, 3 decimal places)
„ 1: Format 3.4 (3 integral, 4 decimal places)
Notes:
„ With DIN PLUS programs, the unit of measure defined in the program head is decisive — regardless of the
unit of measure set here.
„ Restart the CNC PILOT whenever you have changed the unit of measure.
8 Settings for load monitoring
Calculation of limit values: Limit value = reference value * factor for limit value
Evaluation: Load monitoring
„ Factor of torque limit 1
„ Factor of torque limit 2
„ Factor of working limit value
„ Minimum torque [% of rated torque]: Reference values below this value are raised to this minimum torque
value. This prevents that limit values are exceeded as a result of minor torque differences.
„ Maximum file size [KB]: If the data during measured value registration exceed the maximum file size, the
“oldest” values are overwritten.
Rule of thumb: One component requires approx. 12 KB per minute of program run time.
10 Post-process measuring
Evaluation: Post-process measuring
„ Switching measurement on/off
„ 0: Post-process measurement off
„ 1: Post-process measurement on. The CNC PILOT is ready to receive data.
„ Type of measurement
„ 1: Post-process measuring
„ Measured value coupling
„ 0: New measured values overwrite old measured values.
„ 1: New measured values are not received until the old measured values are evaluated.
Note: In control parameters 40, ..., the serial interface is selected and the interface parameters are defined.