HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 369)

HEIDENHAIN CNC PILOT 4290 369
5.1 Simulation Mode of Oper
ation
Setting the simulation window
Window selection dialog box:
U Select “Set up > Window”: The CNC PILOT opens the dialog box
for the settings listed below.
Set:
„ The window combination
„ The path display in the supplementary windows: The front window,
surface window, and side view are considered supplementary
windows. The following setting specifies whether the simulation
depicts traverse paths in the windows.
„ Automatic: The simulation displays traverse paths if the C axis
has been oriented or a G17 or G19 has been executed. G18 or a
C axis out of orientation stops output of the traverse paths.
„ Always: The simulation shows the traverse path in all simulation
windows.
„ Source block display: The block display displays the programmed
NC blocks (NC source blocks) of one or more slides. Set:
„ Source block display for the currently specified slides
„ Source block display for the marked slides