HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 82)

82
3.5 A
u
to
matic Mode
Program selection
The CNC PILOT interprets the NC program before it can be activated
with Cycle Start. “#-Variables” are entered during the translation
process. A “restart” prevents a new translation, while a “new start”
forces a new translation.
Program selection
Select Prog > Program selection The CNC PILOT opens the list of NC
programs.
Select the NC program
The NC program is loaded without previous translation if:
No changes were made to the program or tool list.
The lathe was not switched off since the program was last selected.
Restart
Select Prog > Restart selection
The most recently active NC program is loaded without previous
translation if:
No changes were made to the program or tool list.
The lathe was not switched off since the program was last selected.
„ If the “turret table” of the NC program is not the
currently valid table, there is a warning.
„ The name of the NC program is retained until you select
another program, even if the lathe was switched off in
the meantime.