HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 63)

HEIDENHAIN CNC PILOT 4290 63
3.2 Manual Contr
o
l Mode
Insert the nominal tool
U Select T. Enter the turret position, or
U the next turret position, or
U the previous turret position, or
Functions of the tool change:
„ Move the tool into position
„ Calculate “new” tool dimensions
„ Display “new” actual values in the position display
M commands in Manual Control mode
In the menu group M you either type in the M function to be run or you
select the desired function from the menu.
To run an M function:
U Select M > M direct
U Enter the M number (“M function” dialog box)
U Cycle Start runs the M function
U “Cycle stop” exits the dialog box
To select and run an M function:
U Select “M function”
U Using the menu, select the M function
U Cycle Start runs the M function
U “Cycle stop” exits the dialog box
The content of the M menu depends on the machine.
Yours may differ from the example shown here.