Rockwell Automation IASIMP Computer Numerical Control (CNC) Machining Accelerator Toolkit Quick Start - Manual (Page 83)

Rockwell Automation Publication IASIMP-QS034A-EN-P - October 2012 83
GuardLogix Configuration
Chapter 4
Follow These Steps
Complete these steps to import and configure logic modules for your FANUC CNC application.
Start
No Yes
No Yes
Are you familiar with
the RSLogix 5000 software
programming environment,
motion instructions,
and programming
PowerFlex drives?
Are you using the
DMAT Wizard to configure
the initial GuardLogix controller
and Kinetix/PowerFlex drive
configuration and logic? page 87
GuardLogix Controller and
Network Configuration
page 91
Import and Configure the
Machine Logic Module
page 100
Import and Configure CNC
Application Logic Module
Set Visible Rows for Equipment
Status Faceplate
page 84
Create an Initial GuardLogix Project
Using the DMAT Wizard
Import and Configure FANUC CNC
Device Logic Modules
page 126
Application Logic Creation Steps
That Use Application Logic Examples
page 136
Application Logic Creation Steps
That Use a Template
page 137
Verify and Save the Project File
page 95
FANUC CNC AOP
Configuration
Optional Step
Complete if Alarm
History faceplate is
used in application.
Optional Step
Complete if Equipment
Status faceplate is
used in application.
Safety Logic Integration
Set String Tag Names for
Alarm History Faceplate
Create Specific
Application Logic
Import and Configure Device
and Application Status Logic
page 104
page 108
page 111
page 113
page 120
page 146