Rockwell Automation IASIMP Computer Numerical Control (CNC) Machining Accelerator Toolkit Quick Start - Manual (Page 185)

Rockwell Automation Publication IASIMP-QS034A-EN-P - October 2012 185
FactoryTalk View ME Configuration
Chapter 5
Configure Equipment Status Faceplate Display
The equipment status faceplate display provides a summary status of the devices in your system and another
launch site for your individual device faceplates.
The equipment status faceplate files let you quickly load and configure a summary display of preconfigured status
and diagnostic displays or faceplates for FactoryTalk View Machine Edition. The equipment status faceplate
works in conjunction with individual device faceplates and provides a single summary display of all the device
faceplates that may be configured for an application. You can configure up to nine device faceplates to run with
the equipment status faceplate, and you can launch each device faceplate directly from the equipment status
faceplate.
Figure 28 - Example of Equipment Status Display Configured with Four Device Faceplates
IMPORTANT This section is optional and necessary only if you intend to use the equipment status faceplate.
You can launch these
faceplates from the Goto
buttons.
(Drill CNC shown)