Rockwell Automation IASIMP Computer Numerical Control (CNC) Machining Accelerator Toolkit Quick Start - Manual (Page 26)

26 Rockwell Automation Publication IASIMP-QS034A-EN-P - October 2012
Chapter 1
Architecture and Hardware Selection
3. Select the drives and motors for the
application
a. Use the tabs near the bottom of the
spreadsheet to navigate to and
select the appropriate voltage for
the drives, based on your system
power voltage.
For the CNC Work Cell example,
460V drives is selected.
The 460V drives tab is displayed.
b. Use the cells in the spreadsheet to
navigate to and select the
appropriate motors and drives,
based on your specific application
requirements.
The 460V drives selections are
displayed.
c. Use the cells in the spreadsheet to
navigate to and select the
appropriate motor and drive
options. When all options are
selected the cell at the bottom of the
tab (U801) will display either a
TRUE OVERALL or FALSE
OVERALL status. Make the
appropriate corrections until the
status reads, TRUE OVERALL.
The 460V drives configuration is now
complete.