Before you begin, What you need, Before you begin what you need – Rockwell Automation IASIMP Computer Numerical Control (CNC) Machining Accelerator Toolkit Quick Start User Manual
Page 30
30
Rockwell Automation Publication IASIMP-QS034A-EN-P - October 2012
Chapter 2
System Layout and Wiring
This section uses the CNC Work Cell application example to help you understand how to use the drawing
libraries. The CNC Work Cell includes the following main devices:
•
Two FANUC 35i-B CNC systems
•
Two Kinetix 6500 servo drives and motors
•
One GuardLogix safety controller and EtherNet/IP network module
Before You Begin
Complete your system architecture and hardware selection (see
Chapter 1
).
What You Need
•
CNC Machining Accelerator Toolkit DVD, publication
. For a copy of the DVD, contact
your local Rockwell Automation distributor or sales representative.
•
AutoCAD Electrical software to open the DWG or DXF files.
•
Adobe Reader software to open PDF files.
•
System Design for Control of Electrical Noise Reference Manual, publication
•
System Design for Control of Electrical Noise Video, publication GMC-SP004.
•
If Rockwell Automation Kinetix or PowerFlex Drives are used in the system, the Drives and Motion
Accelerator Toolkit DVD is required, publication
or a copy of the DVD, contact your
local Rockwell Automation distributor or sales representative.
•
If Rockwell Automation GuardLogix safety controller and safety components are used in the system, the
Safety Accelerator Toolkit DVD is required, publication
. For a copy of the DVD,
contact your local Rockwell Automation distributor or sales representative.