Rockwell Automation IASIMP Computer Numerical Control (CNC) Machining Accelerator Toolkit Quick Start - Manual (Page 261)

Rockwell Automation Publication IASIMP-QS034A-EN-P - October 2012
261
Appendix
D
Logix Communication and Controller Configuration
In this appendix, you configure your personal computer and controller communication, configure your
controller, and create a new project by using RSLogix 5000 software.
Configure Personal Computer Communication Properties
In this example, you set and verify the IP address of the personal computer running your program.
Set the IP Address
1. On your desktop, right-click My Network
Places and choose Properties.
2. Double-click Local Area Connection.
3. On the General tab, select Properties.
4. Verify Internet Protocol (TCP/IP) is
checked and selected.
5. Click Properties.
6. Select Use the following IP address.
7. Enter the IP address and Subnet mask as
shown, or enter your address.
8. Click OK.
9. Close all network windows.