Rockwell Automation IASIMP Computer Numerical Control (CNC) Machining Accelerator Toolkit Quick Start - Manual (Page 41)

Rockwell Automation Publication IASIMP-QS034A-EN-P - October 2012 41
System Layout and Wiring
Chapter 2
Edit System Communication Drawings
1. Open the following communication drawings to access your project's EtherNet/IP configuration drawings:
• 15_CNC_Ethernet_Communication
• 16_CNC_Ethernet_Switch
• 18_CNC_Cable_Connections
2. Delete and or copy network devices to match your system requirements.
The 15_CNC_Ethernet_Communication drawing is shown in Figure 7 on page 42 . It includes both
FANUC CNC system and Rockwell Automation GuardLogix, PanelView, and Kinetix/PowerFlex Drive
EtherNet/IP connections. Simply delete and/or copy EtherNet/IP devices to match your project
requirements.
The 16_CNC_Ethernet_Switch and 18_CNC_Cable_Connections drawings include references to
FANUC CNC system and Rockwell Automation EtherNet/IP devices, cables, and connections. Delete
and or copy components to match your project requirements.
3. Access other Rockwell
Automation device footprints
required for your application.
To access Rockwell
Automation Kinetix or
PowerFlex drive system
footprints, including HMI
and other power components,
use the Drives and Motion
Accelerator Toolkit DVD,
publication
IASIMP-SP017 .
Navigate to the CAD drawing
libraries layout section
directories for a variety of
device footprints.