Rockwell Automation IASIMP Computer Numerical Control (CNC) Machining Accelerator Toolkit Quick Start - Manual (Page 54)

54 Rockwell Automation Publication IASIMP-QS034A-EN-P - October 2012
Chapter 3
FANUC CNC Configuration
The chapter selection screen to display the
fast Ethernet options is displayed.
3. Press the ETHERNET softkey to view the
settings and selections of the fast Ethernet
board.
4. Press the COMMON softkey to view the
common settings of the fast Ethernet board. It
may be necessary to press either the + softkey
or the right arrow function key to advance to
the chapter selection for Ethernet common.
5. Use the arrow keys on the MDI panel to move
to the IP ADDRESS field, then enter the IP
address for your configuration by using the
number keys on the MDI panel. The example
uses the IP address 192.168. 30.80
6. Use the arrow keys on the MDI panel to move
to the SUBNET MASK field, then enter the
mask for your configuration by using the
number keys on the MDI panel. The example
is using the mask 255.255.255.0