Rockwell Automation IASIMP Computer Numerical Control (CNC) Machining Accelerator Toolkit Quick Start - Manual (Page 25)

Rockwell Automation Publication IASIMP-QS034A-EN-P - October 2012 25
Architecture and Hardware Selection
Chapter 1
2. Select the System I/O.
a. Use the tabs near the bottom of the
spreadsheet to navigate to and select
the IOetc tab, for I/O selection.
The IOetc tab is displayed.
b. Use the cells in the spreadsheet to
navigate to and select the
appropriate I/O modules, based on
your specific application
requirements.
The 35i-B selections are displayed.
c. Use the cells in the spreadsheet to
navigate to and select the
appropriate I/O and options.
When all options are selected the
cell at the bottom of the tab (U268)
will display either a TRUE
OVERALL or FALSE OVERALL
status. Make the appropriate
corrections until the status reads
TRUE OVERALL.
The I/O configuration is now complete.
TIP The Status is FALSE until the
I/O selection has been satisfied
in the next step.