GW Instek APS-1102A User Manual - Manual (Page 89)

4 ADVANCED OPERATION EXAMPLE
APS-1102A 4-17
4.2.3 Set measurement display to peak value
Set the displayed current measurement value to the peak value (PEAK).
To change the displayed current measurement value, select “MEASURE” in the MISC menu .

Operation steps
1. Press the or key to move the cursor to the icon, then press the
EN TER
key.
ENTER CANCEL
Cursor

The MISC menu is displayed.
2. Press the or key to move the cursor to “MEASURE”, then press the
EN TER
key.

The selection box is displayed.
ENTER CANCEL
Selection box
3. Press the or key to move the cursor to “PEAK”, then press the
EN TER
key.

This sets the measurement display to the peak value (PEAK).
ENTER CANCEL