GW Instek APS-1102A User Manual - Manual (Page 153)

5 MENUS
APS-1102A 5-19
5.3.4 Setting output frequency
This sets the AC voltage frequency.
When either AC-SYNC or AC+DC-SYNC mode is selected, the AC voltage frequency cannot be set.
Table5-14. Output Frequency Setting
Setting Range Resolution Setting Accuracy
1.0 Hz to 550.0 Hz 0.1 Hz

0.01% (1.0 Hz to 550.0 Hz，23

5

C)
S ee “3.4.7 Using limiter functions”, when using a setting range limit for output frequency.

Operation steps
To set the output frequency, set a numerical value labeled in the SET menu.
See “3.4.6 Setting output frequency”, for description of output frequency settings.
S ee “5.5.5 Setting range limiter (LIMIT)”, for description of setting range limits.
------- ！ CAUTION ----------------------------------------------------------------------------------------------
If the frequency is set under 40 Hz in AC-INT mode, there is a possibility that the output
waveform will be distorted and DC offset will be output.
----------------------------------------------------------------------------------
5.3.5 Output initial phase settings
When AC-INT, AC-ADD, AC-SYNC, AC+DC-INT, AC+DC-ADD, or AC+DC-SYNC mode is selected,
the AC voltage phase can be set according to the internal signal source when output is on.
Table5-15. Output Initial Phase Settings
Setting Range Resolution
0.0

to 359.9

0.1


Operation steps
To set the phase, select in the SET menu and set a numerical value.
For description of the output initial phase:
See “4.2.2 Set phase at output on”.