GW Instek APS-1102A User Manual - Manual (Page 187)

6 REMOTE INTERFACE
APS-1102A 6-3
3. Press the
EN TER
key to display the selection box.
ENTER CANCEL
4. Press the or key to move the cursor to “USB”.
ENTER CANCEL
5. Press the
EN TER
key to complete the setting. Press the
CA NCE L
key to cancel the setting.
6. Use a commercially available USB cable (Type A to B) to connect this product to the computer.
USB connector is available on the rear of this product.
------- Notes --------------------------------------------------------------------------------------------------------
 Avoid use in a place that has power fluctuation or under electrically noisy environment .
 It is recommended to use a fully-shielded, short cable.
 The use of USB hub may cause the product not to communicate properly.
 Do not turn off the power during USB communication.
-------------------------------------------------------------------------------------------------------------------------