GW Instek APS-1102A User Manual - Manual (Page 189)

6 REMOTE INTERFACE
APS-1102A 6-5
3. Press the
EN TER
key to display the selection box.
ENTER CANCEL
4. Press the or key to move the cursor to “INTERFACE”.
ENTER CANCEL
5. Press the
EN TER
key to complete the setting. Press the
CA NCE L
key to cancel the setting.
6. Use a D-sub 9-pin cross cable to connect this product to the computer. The connector is on the rear
of APS-1102A.

Operation steps <2>
Set communication parameter by following steps below.
1. Open SYSTEM MENU to open “REMOTE”.
ENTER CANCEL