GW Instek APS-1102A User Manual - Manual (Page 165)

5 MENUS
APS-1102A 5-31
Table5-22. PROGRAM Screen Items (3/3)
Setting Name Item Operation
STEP TERM Step end
Sets operation after end of step.
Select one of the following three options.

CONT: Sequence continuation

STOP: Change to Idle mode

HOLD: Change to Hold mode
JUMP STEP Jump step
Sets the step number to jump to after the end of the
previous step.

0: Continue to next step number

1 to 255: Jump to specified step number
JUMP NUM Jump times
Sets the number of times to execute the jump operation
specified by JUMP STEP.

0: Infinite times jump

1 to 999: Specified times jump
BRANCH0 Branch step 0
Sets the step number to jump to when trigger input has
occurred.
Two types of branch steps can be set: BRANCH0 and
BRANCH1.
[Command example]
When a STOP is set after a small number of sweeps at the
jump destination step, it enables uses where there is a
safe region for saving data if necessary.

0: Branch disabled

1 to 255: Jump to specified step number
BRANCH1 Branch step 1
c) MEMORY
…(clears sequence memory)
This clears the sequence memory.
When this cleared, the initial value is input.
See “4.4.5 Clear sequence memory”.
See “Table3-1. Settings in Memory”.