GW Instek APS-1102A User Manual - Manual (Page 191)

6 REMOTE INTERFACE
APS-1102A 6-7
6.2 Command List
The APS-1102A command list is shown in Table6-1 to Table6-9 and IEEE488.2 common commands
supported by the APS-1102A are listed in Table6-11.
The symbols used in Table6-1 to Table6-11 are explained below. The lowercase letters in each keyword
can be omitted.

Square brackets indicate keywords that can be omitted. (Implicit keywords)

A vertical bar ( | ) indicates that one of several keywords is selected.
Table6-1. Command List (SOURce Subsystem)(1/2)
Function Command
RMS current limiter [SOURce:]CURRent:LIMit:RMS
Average current limiter [SOURce:]CURRent:LIMit:AVErage
Note
Peak current limiter (positive) [SOURce:]CURRent:LIMit:PEAK:HIGH
Peak current limiter (negative) [SOURce:]CURRent:LIMit:PEAK:LOW
Output frequency [SOURce:]FREQuency[:IMMediate]
Frequency upper limit setting limit [SOURce:]FREQuency:LIMit:HIGH
Frequency lower limit setting limit [SOURce:]FREQuency:LIMit:LOW
Output waveform [SOURce:]FUNCtion[:SHAPe][:IMMediate]
Output mode [SOURce:]MODE
Sync signal source (external
synchronization mode)
[SOURce:]PHASe:CLOCk
Phase when output is started [SOURce:]PHASe[:IMMediate]
Sequence status [SOURce:]SEQuence:CONDition?
Step number during execution [SOURce:]SEQuence:CSTep?
Maximum number of steps in sequence [SOURce:]SEQuence:LEN?
Jump number of times in step specified by
SEQ:STEP command
[SOURce:]SEQuence:COUNt?
Clear sequence memory [SOURce:]SEQuence:DELete
Step execution parameter [SOURce:]SEQuence:EPARameter
Step transition parameter [SOURce:]SEQuence:TPARameter
Target step number for sequence editing [SOURce:]SEQuence:STEP
AC output voltage [SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]
Output voltage upper limit setting limit [SOURce:]VOLTage:LIMit:HIGH
Output voltage lower limit setting limit [SOURce:]VOLTage:LIMit:LOW
DC output voltage
(during AC+DC-INT, AC+DC-ADD, or
AC+DC-SYNC mode) [SOURce:]VOLTage:OFFSet[:IMMediate]
Note This command is compatible with APS-1102.
( See “[SOURce:]CURRent:LIMit:AVErage” on page 6-19.)