GW Instek APS-1102A User Manual - Manual (Page 270)

APS-1102A User Manual
APS-1102A 9-4
h) Maximum output current
100 V range: 10 Arms (AC) / 10 A (DC)
200 V range: 5 Arms (AC) / 5 A (DC)
Note 1:For the AC 100 V input system, the limit on the
maximum output power may cause a reduction in the
maximum output current.
Note 2:If the output voltage is higher than the rated value,
this is limited (lowered) to satisfy the power
capacity.
Note 3:When output frequency is 40 Hz or lower, or it is 400
Hz or higher, the maximum output current may
decrease.
Note 4:The RMS value for AC + DC is within the maximum
output current.
i) Maximum output peak current
100 V range: 40 Apk
200 V range: 20 Apk
Note 1: For the AC 100 V input system, the limit on the
maximum output power may cause a reduction in the
maximum output peak current.
Note 2: The above values are for the capacitor input type
rectifier circuit whose crest factor is 4 or less.
Note 3: If the output voltage is higher than the rated value, the
limit on the maximum output power may reduce the
maximum output peak current.
Note 4: When output frequency is 45 Hz or lower, or it is 65 Hz
or higher, the maximum output peak current may
decrease.
j) Frequency setting (When signal source mode is INT and ADD mode only)
Setting range: 1.0 Hz to 550.0 Hz
Setting resolution: 0.1 Hz
Setting accuracy:

0.01% (23

5°C)
k) Output on phase (When signal source mode is INT and ADD mode only)
Setting range: 0.0

to 359.9

Setting resolution: 0.1

l) Output voltage waveform (When signal source mode is INT and ADD mode only)
Sine wave, square wave, arbitrary waveform (16 types)