GW Instek APS-1102A User Manual - Manual (Page 115)

4 ADVANCED OPERATION EXAMPLE
APS-1102A 4-43
 Setting step 2
10. Press the or key to move the cursor to “STEP”.
11. Press the
EN TER
key to display the modification box.
12. Press the and keys to move the cursor to 1’s place, then turn the MODIFY dial to set “2”.
The set value will be reflected in output immediately.
13. Press the
CA NCE L
or
EN TER
key to close the modification box.
14. Press the key to move the cursor to “TIME”.
15. Press the
EN TER
key to display the modification box.
16. Press the and keys to move the cursor to the 0.1’s place, then turn the MODIFY dial to set
“2” (this sets “0.2 seconds”). The set value will be reflected in output immediately.
17. Press the
CA NCE L
or
EN TER
key to close the modification box.
18. Using the same operations as in steps 2 to 5, set DC VOLT = 25, and using the same operations as
in steps 7 to 9, set the DC voltage operation type as “KEEP”.
Use the same operation steps to set step 3 and subsequent steps.