GW Instek APS-1102A User Manual - Manual (Page 226)

APS-1102A User Manual
APS-1102A 6-42

TRACe:DELete[:NAME]
This clears the specified arbitrary waveform memory. When this command is executed, a sine
wave is written to ARB1 to ARB8, a square wave is written to ARB9 to ARB12, and a triangle
wave is written to ARB13 to ARB16.
However, when output is on, the arbitrary waveform memory cannot be cleared. ([1, “Invalid with
output on”] error occurs.)
Syntax: TRACe:DELete[:NAME]
Parameters: ARB1 to ARB16
Command example: TRAC:DEL ARB1
Response format: None
Response example: None
j) SYSTem subsystem

SYSTem:BEEPer:STATe
This controls the beep on/off setting. When the beep sound is enabled, beeps accompanying cursor
operations become enabled, and an operation error or a protected operation will be notified with a
beep.
Syntax: SYSTem:BEEPer:STATe
Parameters: OFF | 0 / ON | 1
Command example: SYST:BEEP:STATe ON
Query example: SYST:BEEP:STATe?
Response format:
Response example: 1

SYSTem:CONFigure:EXTIO
This controls the external control input enable/disable setting.
Syntax: SYSTem:CONFigure:EXTIO
Parameters: OFF | 0 / ON | 1
Command example: SYST:CONF:EXTIO ON
Query example: SYST:CONF:EXTIO?
Response format:
Response example: 1