GW Instek APS-1102A User Manual - Manual (Page 47)

3 PANEL AND BASIC OPERATIONS
APS-1102A 3-13
3.3.4 External control I/O
The APS-1102A is equipped with an (8-bit) external control I/O connector to enable external control
using digital signal input and status output using digital signals. The connector is a D-sub 25-pin type.
External control I/O
connector
Figure 3-9. External Control I/O Connector
The signals corresponding to the pins in this connector are listed below in “Table3-6 External Control
I/O Connectors”