GW Instek APS-1102A User Manual - Manual (Page 33)

2 PREPARATIONS BEFORE USE
APS-1102A 2-9
2. Panel settings
Set the APS-1102A as shown below. See “3.4 Main Operation Example”, for descriptors
of the settings methods.
Table2-1. Panel Settings for Operation Check
Item Setting
Output mode AC-INT mode
Output voltage range 100 V
AC output voltage 100 Vrms
Selected measurement display RMS
3. Press the
OUTPUT
key to turn on output.
OUTPUT OUTPUT
Output is off. Output is on.
⇒ Check that the control panel MEASURE screen shows 100 Vrms as the AC output voltage.
Figure 2-3. Operation Check
⇒ If the normal values are not displayed, it may be due to an operation fault. Contact GW Instek or
our agent.
4. When you turn off the power, check the OUTPUT on/off LED is off. Then press the power
switch to the bottom () position. This shuts off the power supply and turns off the power
source unit.
Before turning off the power, make sure that the output on/off LED is off.
Output on/off LED is on.
Check display.
！ CAUTION