GW Instek APS-1102A User Manual - Manual (Page 203)

6 REMOTE INTERFACE
APS-1102A 6-19

[SOURce:]CURRent:LIMit:AVErage
This sets the upper limit for the output RMS current. The output RMS current limiter setting
ranges from 1.0 A to 10.5 A (for 100 V range) or from 1.0 A to 5.3 A (for 200 V range). To keep
compatible with APS-1102, current average limiter command of APS-1102 can be used as RMS
limiter command of APS-1102A.
Syntax: [SOURce:]CURRent:LIMit:AVErage
Parameter: 1.0 to 10.5 (1.0 to 5.3)
Command example: CURR:LIM:AVE 5
Query example: CURR:LIM:AVE ?
Response format:
Response example: 5.0

[SOURce:]CURRent:LIMit:PEAK:HIGH
This sets the upper limit of the output peak current (positive polarity). The output peak current
limiter (positive polarity) setting ranges from 10.0 A to 42.0 A (for 100 V range) or from 5.0 A to
21.0 A (for 200 V range).
Syntax: [SOURce:]CURRent:LIMit:PEAK:HIGH
Parameters: 10.0 to 42.0 (5.0 to 21.0)
Command example: CURR:LIM:PEAK:HIGH 10
Query example: CURR:LIM:PEAK:HIGH?
Response format:
Response example: 10.0

[SOURce:]CURRent:LIMit:PEAK:LOW
This sets the upper limit for output peak current (negative polarity). The output peak current
limiter (negative polarity) setting ranges from

42.0 A to

10.0 A (for 100 V range) or from

21.0
A to

5.0 A (for 200 V range).
Syntax: [SOURce:]CURRent:LIMit:PEAK:LOW
Parameters:

42.0 to

10.0(

21.0 to

5.0)
Command example: CURR:LIM:PEAK:LOW

10
Query example: CURR:LIM:PEAK:LOW?
Response format:
Response example:

10.0