GW Instek APS-1102A User Manual - Manual (Page 204)

APS-1102A User Manual
APS-1102A 6-20

[SOURce:]FREQuency[:IMMediate]
This sets the output frequency. When in AC-EXT/AC-SYNC/AC+DC-EXT/AC+DC-SYNC
mode, the frequency cannot be set. ([3, “Invalid in this mode”] error occurs.)
The frequency setting ranges from 1.0 Hz to 550.0 Hz.
Syntax: [SOURce:]FREQuency[:IMMediate]
Parameters: 1.0 to 550.0
Command example: FREQ 50
Query example: FREQ?
Response format:
Response example: 50.0

[SOURce:]FREQuency:LIMit:HIGH
This sets the upper limit of the frequency that can be set. However, a value that is equal to or lower
than the currently set frequency cannot be set. ([5, “Out of Limiter”] error occurs.)
The limit value setting ranges from 1.0 Hz to 550.0 Hz.
Syntax: [SOURce:]FREQuency:LIMit:HIGH
Parameters: 1.0 to 550.0
Command example: FREQ:LIM:HIGH 550
Query example: FREQ:LIM:HIGH?
Response format:
Response example: 550.0

[SOURce:]FREQuency:LIMit:LOW
This sets the lower limit of the frequency that can be set. However, a value that is equal to or
higher than the currently set frequency cannot be set. ([5, “Out of Limiter”] error occurs.)
The limit value setting ranges from 1.0 Hz to 550.0 Hz.
Syntax: [SOURce:]FREQuency:LIMit:LOW
Parameters: 1.0 to 550.0
Command example: FREQ:LIM:LOW 50
Query example: FREQ:LIM:LOW?
Response format:
Response example: 50.0