HEIDENHAIN TNC 407 (280 580) ISO Programming - Manual (Page 93)

TNC 426/TNC 425/TNC 415 B/TNC 407 3-7
3 Test Run and Program Run
3.2 Program Run
CE
OFF
ON
0
I
Resuming program run after an error
• If the error message is not blinking:
Remove the cause of the error.
Clear the error message from the screen.
Restart the program, or resume program run at the place at which it was interrupted.
• If the error message is blinking:
Switch off the TNC and the machine.
Remove the cause of the error.
Start again.
• If you cannot correct the error:
Write down the error message and contact your repair service agency.