3d touch probes and digitizing -4 – HEIDENHAIN TNC 407 (280 580) ISO Programming User Manual
Page 301
11-4
11
Tables, Overviews and Diagrams
TNC 426/TNC 425/TNC 415 B/TNC 407
3D touch probes and digitizing
Select touch probe
MP6200
Triggering touch probe:
0
Measuring touch probe:
1
Select signal transmission
MP6010
Touch probe with cable transmission:
0
Touch probe with infrared transmission:
1
Probing feed rate for triggering touch probes
MP6120
80 to 3 000 [mm/min]
Maximum traverse to first probe point
MP6130
0 to 99 999.9999 [mm]
Safety clearance to probing point during automatic measurement
MP6140
0 to 99 999.9999 [mm]
Rapid traverse for triggering touch probes
MP6150
1 to 300 000 [mm/min]
Measure center misalignment of the stylus when calibrating a triggering touch probe
MP6160
No 180° rotation of the 3D touch probe during calibration:
0
M function for 180° rotation of the 3D touch probe during calibration:
1 to 88
Lubricating the touch probe axis during digitizing with a triggering touch probe
MP6220
Traverse in the touch probe axis at the end of line:
0 to 99 999.9999 [mm]
Lubricating the touch probe axis during digitizing with a triggering touch probe
MP6221
Time after which the axis should be lubricated:
0 to 65 535 [min]
426
426