HEIDENHAIN TNC 407 (280 580) ISO Programming User Manual
Page 306
11-9
11
Tables, Overviews and Diagrams
TNC 426/TNC 425/TNC 415 B/TNC 407
TNC displays, TNC editor
Configure tool table; column number of the data in the tool table for
(Do not show data in the table: enter 0)
MP7266.0
Tool name – NAME:
0 to 24
MP7266.1
Tool length – L:
0 to 24
MP7266.2
Tool radius – R:
0 to 24
MP7266.3
Tool radius – R2:
0 to 24
MP7266.4
Oversize length – DL:
0 to 24
MP7266.5
Oversize radius – DR:
0 to 24
MP7266.6
Oversize radius2 – DR2:
0 to 24
MP7266.7
Tool locked – TL:
0 to 24
MP7266.8
Replacement tool – RT:
0 to 24
MP7266.9
Maximum tool life – TIME1:
0 to 24
MP7266.10
Maximum tool life for TOOL CALL – TIME2:
0 to 24
MP7266.11
Current tool age – CUR. TIME:
0 to 24
MP7266.12
Tool comment – DOC:
0 to 24
MP7266.13
Number of cutting edges – CUT.:
0 to 24
MP7266.14
Length tolerance for tool wear – LTOL:
0 to 24
MP7266.15
Radius tolerance for tool wear – RTOL:
0 to 24
MP7266.16
Cutting direction – DIRECT.:
0 to 24
MP7266.17
PLC status – PLC:
0 to 24
MP7266.18
Tool offset in addition to MP6530 between upper edge of stylus and lower edge of tool – TT:L-OFFS.:
0 to 24
MP7266.19
Tool offset between stylus center and tool center – TT:R-OFFS.:
0 to 24
MP7266.20
Length tolerance for tool break – LBREAK:
0 to 24
MP7266.21
Radius tolerance for tool break – RBREAK:
0 to 24
Additional machine parameters for TNC 426
MP7266.22
Tooth length (Cycle 22) – LCUTS:
0 to 24
MP7266.23
Maximum plunge angle (Cycle 22) – ANGLE:
0 to 24