HEIDENHAIN TNC 407 (280 580) ISO Programming - Manual (Page 87)

TNC 426/TNC 425/TNC 415 B/TNC 407 2 - 2 6
2 Manual Operation and Setup
or
4 5 e.g.
ENT
ENT
2.7 Tilting the Working Plane
Fig. 2.21: Menu for manual tilting in the MANUAL
OPERATION mode
To activate manual tilting:
Select menu for manual tilting.
Select the tilt axis.
Enter the tilt angle (for example, 45°).
Set TILT WORKING PLANE to ACTIVE.
Conclude input.
A symbol for the tilted plane is shown in the status display
whenever the TNC is moving the machines axes in the
tilted plane.
If you have set the function TILT WORKING PLANE to ACTIVE in the PROGRAM RUN mode of operation, the tilt
angle entered in the menu becomes effective in the first block of the part program to be executed. If you have
entered cycle G80 WORKING PLANE in the part program, the angular values defined in the cycle become effective
immediately after cycle definition. Angular values entered in the menu will be overwritten.
To reset:
Set TILT WORKING PLANE to INACTIVE.