HEIDENHAIN TNC 407 (280 580) ISO Programming - Manual (Page 208)

7-19 TNC 426/TNC 425/TNC 415 B/TNC 407
7 Programming with Q Parameters
Group name Group No. Number Index System data
Active transformations 210 1 – Basic rotation in MANUAL mode
2 – Rotation programmed with Cycle 10
3 – Active mirror axis
0: mirroring not active
+1: X axis mirrored
+2: Y axis mirrored
+4: Z axis mirrored
+8: IV axis mirrored
+16: V axis mirrored
Combinations = sum of individual axes
4 1 Active scaling factor in X axis
4 2 Active scaling factor in Y axis
4 3 Active scaling factor in Z axis
4 4 Active scaling factor in IV axis
4 5 Active scaling factor in V axis
5 1 3D ROT A axis
5 2 3D ROT B axis
5 3 3D ROT C axis
Example: Read a BASIC ROTATION from the MANUAL mode
and store it in Q25
D18 Q25 P01 210 P02 1
Transfer to the PLC
The function D19: PLC transfers up to two numerical values or
Q parameter contents to the PLC.
Increments and units: 0.1 µm or 0.0001°
Example D19 P01 +10 P02 +Q3
The numerical value 10 means 1 µm or 0.001°.
7.6 Diverse Functions